Vanguard Oil Tools & Services

CSSB -  Weight set barrier, strong, robust. No rotation required to set the CSSB.

This equipment also carries an integral shear indicator sub to allow the operator / driller a “positive” shear indication when setting down hole leaving no doubt that the appropriate setting weight has been transferred to the liner top. It can also be run with sand screens.

TZIP is a Temperature set packer that provides single-trip speed and efficiency for:

Intelligent completions.

Deviated and horizontal well completions.

Zonal isolation.

High-pressure and high-temperature zones.

TBSA is the working seal between formation pressure and the production tubing. 

The TBSA is used in single- or multiple-zone installations to provide a surface indication that the seal assembly is correctly positioned in the polished bore Production tubes, tailpipe and other accessories can be added below.

TBSA can be configured for all sizes, run at the end of the tubing and stabbed into the exisitng liner top or lower packer's PBR. The PBR length will be determined based on the amount of themal movement calculated.

Tubing above the TBSA can be crossed over to larger size if required.

KTTJ is a Travel Joint, which will be located below the Mechanical-set Liner Hanger and has effective travel of 15 feet.

The Travel Joint is keyed to allow for transmitting torque through the entire assembly, and is fitted with 600 deg F seals. Pressure Rating is 3000 psi. Typical operations include thermal expansion and contraction during production or for injection wells . The Travel Joint can also be run in hole pinned in the closed or open position.

The travel joint can be manufactured in all sizes and lengths for thermal expansion or contraction applications as well as completion or liner space outs.

Once weight is applied from above and the pins shear, the travel joint can be spaced out to accommodate thermal expansion or contraction.

SOSA Primarily designed as a “re-connect” system where a tubing can be cut and retrieved, new tubing whether its standard or insulated, can then be run and connected to the previously cut tubing.

Ideally suited for high temperature environments where insulated tubing replaces standard pipe.

The SOSA can be used primarily as a tubing re-connect system. The upper PBR will accommodate a seal stem for tie back purposes

Available in 5 1/2", 7" and 9 5/8". Shear values dependent on well design.

Installed in casing string to prevent casing buckling due to thermal expansion or reservoir compaction (or dilation)

Available in most common sizes

Run within the producing reservoir

Proven to mitigate casing buckling

Features, Advantages and Benefits:

Mandrel  machined to match the production tubing specifications for ID and drift.

RH release anchor with +/- 100,000 lbs. shear release.

Special lockable anchor, will not latch into the receptacle before 80,000 lbs. is down weight is applied.

Locator designed to uniformly distribute slack-off weight and thermal expansion loads. The locator is threaded with the production tubing connection to eliminate crossovers.

Spacer tube, as required, is manufactured from tubing.